HELP!!! Delta 2 front bumper HELP!!!

[F188CHG]

How do i go about making brakets to fit it as nothing came with the bumper!!! Thanks :cry:

[Dod]

Dont, burnn it or throw it away. They're orrible IMO. Try your local hard ware store and ask them, they'll kit you up.

[F188CHG]

Can i fiberglass it to the bumper beem??? :roll:

[Jack]

Not exactly the same, but similar principal: on my Evo bumper I took the bumper bar from the original bumper, and made some U shaped metal brakets to bolt to that. The tops of the U shape were flanged out and fibreglassed to the bumper, the bottom of the U was bolted to the bumper bar.

Same again on the sides - couple of U shaped brakets from the wing to the bumper. Easy on the Evo bumper as its quite wide, but not sure how much room you have on the RJ one.

To add a little support underneath I fibreglassed some L shaped brackets to the back of the bumper which bolted to the bottom of the front valance.

If yours is a Mk2, as mine was, you might find it useful to help pull the bumper up a bit by putting some bolts thru the bottom of the grille into the bumper.