View Full Version : TAS engine mount bolt needed
i've got a set of tas engine mounts but i don't have the bolt for the drivers side mount, anyone know what size it is and where i can get one??
cheers
ben
I have aske3d the same question mate before, my drivers side mount still sits in my garage !
M10 seemed to small so I'd say a M12 bolt would be what your after :)
i know the bolt of the rear gearbox mount is a good fit, but i don't have a nut for it
m12x1.25 mate
b&q ?2 bolt and nut (make sure you get a hex head or it wont sit flush)
the pitch sorry a std m12 bolt really just used to putting the pitch from work :D
been to B+Q and wicks' neither had any
lol when do you need it for ben ill go get you one tomorrow if you want and post it you :lol:
asap, but that would be great mate.
ben curry
derryvale
westdene avenue
allenton
derby
de24 9at
Snowface
20-07-05, 11:42 AM
ahum... Pm, i wouldn't post ur address up on the net mate lol.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.