XE throttle breather

[skud52]

on the standard 20xe, when you remove the breather closest to the oil cap (larger diameter), it leaves a hole into the throttle body,

what can i seal this hole with as i want to fit a breather filter to the pipe?

cheers
ben

[Stoo]

Cut a small section of pipe, put it onto the throttle body and bung the other end up with a bolt thicker than the pipe!use some silicone to seal it in!

[skud52]

yea thats what i was going to do, just wondered if there was a more proper way of doing it. all good

cheers