nova_nutta
28-05-05, 10:10 PM
hi all
im now in the middle of build a valver and just realized the drivers side inner wing is rotten for the first inch nearest the wing about 8 inches long would it be ok to plate it ? or a whole new inner wing which from what i can tell is a big expensive job. i was going to just plate it but dint know if would be strong enough for the valver and if it would pass an mot or not. Can sombody whos had this problem or knows a bit more about mots than me help me out and tell me what todo
Cheers
Jay
im now in the middle of build a valver and just realized the drivers side inner wing is rotten for the first inch nearest the wing about 8 inches long would it be ok to plate it ? or a whole new inner wing which from what i can tell is a big expensive job. i was going to just plate it but dint know if would be strong enough for the valver and if it would pass an mot or not. Can sombody whos had this problem or knows a bit more about mots than me help me out and tell me what todo
Cheers
Jay