How do i fit SR clocks in a 1.2?

[Nobby]

How do i do it? is it easy?? cus i havent gt a rev counter on mine??

[mikey14sr]

you need to run a wire to the coil for the revs and a wire to the oil pressure sensor that you hopefully took off the sr for all the guages to work. other than that straight swap.

[Nobby]

fook that then sounds abit dodgy

[Ste L]

depends if its a injection or not, im sure the injection models have a bigger plug at the back, with the wire for the tacho on it...

if its carb'd, have a look behind he clock's in the dash for a green wire doing nothing, that should work the tacho, well it did on my old nova and my mate's

[NovaGuy1400SRi]

with my k reg 1.2i i just unplugged my original dials without rev counter and plugged the sri ones in and rev counter worked straight away :D

[Nobby]

kool, mines the 1.2i k reg expression i will try it wen i gte my clocks!! :D

[Ste L]

think you will need the clocks of a sri or gsi for them to work then mate

[lee2004_]

mines a 1.2 nova, and it was a straight swap over,, still i wanted my digital dash put in, but i havnt got the wiring loom , just the clocks.. so i cant get it done... :cry:

[Mike.]

GTE clock WILL not fit into a mk2 trust me i've tried it lol, SR clocks will again trust me i've done it, the only problem i've found was the rev counter, i still need to make that work

[NovaGuy1400SRi]

my k reg mk2 1.2i spin had the rev counter wire in the connector so i just had to put the connector into the sri clocks and it worked straight away