jasononline
20-04-05, 09:18 PM
I have some live wires I don't need any more and want rid of. Two of them are red, one is the permanent live to the fuel pump relay and the other is a permanent live in the test connector. When looking in the Haynes manual (page 14.36) the wire I don't want is the one between the fuel pump relay (K58) and the 10MM main red wire (30). It show X19 connector which if disconnected would isolate the wires I don't want, where is that X19?
Also there is a blue wire with a spade connector on the end I think it is the one that connects next to the coolant sensor, also not needed
Any ideas just to make everything tidy
Cheers
Jason
Also there is a blue wire with a spade connector on the end I think it is the one that connects next to the coolant sensor, also not needed
Any ideas just to make everything tidy
Cheers
Jason