grille mesh

[markiemark]

:o heres another stupid question.

i have just got a GTE grille for my MK1 nova, and i have some mesh to, the grile is ready for the mesh to be put in,but i have no clue how to do this :oops: apologies for dumbnes.

mark :lol:

[Jim]

1) Cut the slats out from the grille (I used some wire cuters, seemed to snip through the slats)
2) Make sure the mesh fits
3) Secure the mesh by using similar coloured cable ties and cable tie it to the grille (there should be places along the grille where you can cable tie it)

Alternativley, you can cut the mesh a bit bigger than the area and then fold it over where it overlaps the hole for the mesh and secure it on using some sort of glue.

I used cable ties for mine, it was very easy.

Jim

[Jack]

Alternativley, you can cut the mesh a bit bigger than the area and then fold it over where it overlaps the hole for the mesh and secure it on using some sort of glue.
^ I used the glue. No nails did the trick! :lol:

[markiemark]

Thanks guys :D