View Full Version : bump strips(glue)
whitevanman
16-03-05, 12:07 PM
ive just pulled the bump strips off and that glue is a bitch to get off.Anyone have any good tips about what to use other than elbow grease?.Thanks
smithy87
16-03-05, 12:47 PM
Gunk. Swear by it mate, good stuff :D
what i do is use a small bit of paint thinners with a cloth but being carefull not to remove the paint. i then get one of those plastic filler spreaders to scrape it off and it wont scratch paint
sickrabbit
17-03-05, 10:45 PM
Gunk. Swear by it mate, good stuff :D
wot - is this ok on paint ??
smithy87
17-03-05, 11:31 PM
Gunk. Swear by it mate, good stuff :D
wot - is this ok on paint ??
Didn't effect my paint when I debadged the rear, the glue came off a treat. Im not taking my rub-strips off though, so have no idea if the glue is different, and/if it'll effect the paint. Shouldn't do though, why would it not effect the paint on the back of the car, but effect it on the side?
I reckon it'll be fine. IIRC Epo uses it alot.....have a word 8)
i think you'll find epo uses autoglym tar remover if i remember correctly
boiling water and a credit card....
then go over with some tcut
^ same glue on the badges as on the sides. Kinda foamy double sided tape stuff. Noice.
I think epo is on comission from Autoglym :lol:
use a stanley knife blade, and just run it across the stuff then just a bit of warm water to get the last little stains off, worked atreat, but i didnt do it my dad did and he owns his own body shop. but try it.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.