wireing loom

[whitty_nova_1300sr]

hi all i have a 1300sr running twin 40s but i want to go injection for when the engine goes in, how hard is it do.



whitty

[david dixon]

easy, you still use the ignition live (black), rev counter wire (green), all alternator and starter wire should remain the same!

[Aragorn]

gte loom only has 6 wires to connect

perm live (pull from battery via big fuse[30a]) - red
switched live (pull from ignition barrel via fuse [10a]) - black
fuel pump feed (from loom to fuel pump [10a fuse]) - red-blue
green - tacho feed to dash
brown/yellow - ecu light
blue - temp sender to dash

donot use the black wire at the coil for the ignition live as it has a resistor inline and is not suitable
and if your pulling it from the ignition barrel make sure u get the one that stays on at 2 and 3 not the one thats only on at 2 (u need the wire to be live when your cranking the engine ;) )