View Full Version : rev counter on a mk2 1.2
were is the cable for the rev counter on a 1.2 nova
the engine is a carb version not injection
david dixon
15-02-05, 06:29 PM
should already be in the loom
if it's in the loom behind the dash/clocks, it'l be a solid Green Wire.
It may not have one, mine didn't, but some have ? don't ask why.
If not, you'l have to run a wire from the bottom right terminal on the coil (should be unused) to the corresponding terminal on the clocks.
I presume the Rev counter needs a wire rather than a cable ? as i've only done this for a digidash. I don't know where on earth you'd run a cable to if you need to do that, sorry !
Maybe it's worth getting a digidash ?
Nick
Snowface
15-02-05, 06:42 PM
i just used some speaker wire. works fine (until i cut through it while trying to seperate the two apart)
luckily i could use the other wire lol.
yep it doesn't need to be specially thick wire.
mines speaker wire as well i think :-) i don't think it carries much load
There should be a space in the plug behind the dash,strip a bit wire and put it in the space, then feed ihe rest of the wire through to the coil.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.