View Full Version : Aquamist MF2 controller for turbo (info found v handy)
ok guys in after something to control extra fuel to my 1.6 gte turbo(to be) have any of you used this to control your cars? and how easy is it to set up?
Cheers
NovaNeil
08-02-05, 07:30 PM
Have a word with Courtenay mate, they tried to sell me this system a while back before I went DTA, I looked into it a bit and its seems pretty good..... The normal ECU fuels the engine normally, then when on Boost this MF2 thing provides the extra fuel required via a fifth injector and a map sensor.
Courtenay said they had done a few using it to very good effect, and its not that expensive to do.
Neil
yeah i seen it in the demon tweeks catalogue when i was looking for parts, pm'd ya regarding a few things i was need to know also neil,
ok got a load of info regarding this, now its not as dear as the dta unit that u were using neil, the parts u need according to the diagram i got are
For 2D
------------------------------------------
Aquamist MF2 controller ?210 inc
ER627 3-D mappable injector driver
3-30psi adjustable Pres.Sw. N/open(preset @10psi)
Inline 5A fuse assembly
Cable loom (red hood)
ER627 User manual
Assortment of cable clips and hoods in bag
Bosch type two-pin fuel injection plug
--------------------------------------------
For 3D
-----------------------------------------
Map sensor 3 bar ?76
Hers the diagram i got
http://www.scottishnovas.co.uk/personal/AquamistMF2wiring.jpg
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.