View Full Version : hot to remove a nova tailgate
cruisingscotland
03-02-05, 06:02 PM
hey folks just wondering whats the easyest way to remove a tailgate from a nova is there a special tool to take out the pins or whats the tools to use
thanx
Philsutton
03-02-05, 06:05 PM
you can use a screw driver an a hammer, or a small bar.
-Bruce-
03-02-05, 06:06 PM
There is a special tool to remove door pins, i assume the tailgate pins are the same. I would not get it.
Epo on here says that the bonet prop from the nova is the exact size to hammer the pin out!! i would try that!!
Bruce
yep, just take the clips off the pins then knock them through (while supporting the tailgate)
Chris
Philsutton
03-02-05, 06:09 PM
yep, just take the clips off the pins then knock them through (while supporting the tailgate)
yeah it does hurt when it falls on your head
take the glass out first and it will just fall around you lol
1 - Remove the retaining clips from each ball end of the hydraulic lifter/pushrod
2 - Literally unclip the hydraulic lifter.
3 - Disconnect Wiper motor electrics, and the washer jet hose, or just cut through them if your not going to be needing them.
4 - Remove the Retaining clip from the Inside of each hinge bolt.
5 - hit the bolts outwards with a hammer, when the bolt dissapears inside the hinge casing, get a small rod (smaller than the diameter of the bolt) and use that to carry on hitting the bolt outwards.
Tailgates are reasonably heavy, so be prepared to take it's weight.
I managed to fit one in the boot of my car, how ironic.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.