Speedline Allesio's

[Anonymous]

my mate has just got a set of these and wen he put them on his j-reg sr the center caps dont sit properly (ie, they dont feel like there on properly and they wobbel around a bit), however they DO sit flush on my j-reg, can any one explain this???

[Anonymous]

adjust the split pin on the front and remove the dust cap and adjust the pin on the back

16v Engine fitting and advice... mail me for a quote :D

[Anonymous]

cheers mate :D

[Anonymous]

Nope you will have to cut the ends off the CV joints as the bit the nut screws on is to long and hits the center cap! I had to do this on my SRI to get them to fit. Rick

Wahoo my car will be done soon and it will only have cost me about ?13k ish and about 8 months!

[Anonymous]

Or remove some of the material from the back of the centre caps, or fit 3mm spacers as i have,

[Anonymous]

depends on the car rick
on robs saloon cab mine fitted fine with the only mod being removing the dust cap on the rear

http://uk.photos.yahoo.com/bc/ste_sa/vwp?.dir=/Other+Novas+of+Intrest&.src=ph&.dnm=Robs+nova+cab.jpg&.view=t&.done=http%3a//uk.photos.yahoo.com/bc/ste_sa/lst%3f%26.dir=/Other%2bNovas%2bof%2bIntrest%26.src=ph%26.view=t

16v Engine fitting and advice... mail me for a quote :D

[Anonymous]

wot offset are they?

[Anonymous]

et49