better way off sucuring gsi skirts?

[fafnova]

just wonderd as one of mine fell off tonit and ive lost it :( and it was colour code'd :cry: any body tell me a better way to fix it as dont want it to happen to offten was just thinking off drilling the bottom to the bottom off sill lip or bit off mastik in the sill clips!??

[Adam]

Pop rivet the clips on.

[cruisingscotland]

rivit it o or tiger seal?i used both

[~~joycey~~]

i screwed mine straight in the sills with self tapping screws :lol:

[epo]

i screwed mine straight in the sills with self tapping screws :lol:

ditto and used double sided tape

never lost one yet

[Mike]

funny u should ask this, as i put mine on this morning?

i had x10 original vauxhall clips (instead of 16??) and missed of every OTHER clip, i drilled 2mm diameter hole/s into the syll panel and used stainless steel sheet metal screws and they went on sweet!

then i just added some rally slag brembo and koni graphics and i was job done in under 1 hour! :lol:

[sickrabbit]

hopefully , i,ll have a pair of skirts meslf soon.......self tappers all the way ( and an odd blob of tiger seal )

[Mike]

personally i wouldnt use tiger seal/mastic etc on skirts, wot happens if you need/want to take 'em off again?? more hassle than screws!

[kevster]

i had problem with the one on my gsi the bloody top of the skirt would come a way from the rear wing , so i used double side tape from the builder center .

[sickrabbit]

nevr thought of that matey.....
tappers only it is then...
( if AND when i can get a nice skirt that is )

[Mitchybee]

Also, what i was thinking is, wont the sill rust where u have drilled into it? because it is bare metal?

anyway of getting around that?