PDA

View Full Version : Washers jets removal


az_e11
08-01-05, 08:01 PM
Hi, does any one know whether it is an easy job, what is involved as i have got a crome set comin through.

How hard is it??
Mike
08-01-05, 08:51 PM
most aftermarket washers are a pain to fit on a nova because of the clearance form the bonnet, when u open it and as youre shutting it!

how hard, i dont honestly no. shud be piece of pish id imagine?
az_e11
08-01-05, 08:53 PM
most aftermarket washers are a pain to fit on a nova because of the clearance form the bonnet, when u open it and as youre shutting it!

how hard, i dont honestly no. shud be piece of pish id imagine?

ok cherz m8, hope so
Jack
08-01-05, 09:01 PM
It is easy. Can't quite remember how you do it though, I think you've gotta reach under and depress the tangs thenn push them up through.

There's PLENTY of clearance room too.
Custom_Calibra_Nova
09-01-05, 02:59 PM
aftermarket jets wont wash the screen properly if you fit them where the o/e's were. you're best fitting them into the bonnet itself. i put them where the o/e's were myself and it failed the mot cuz it didnt wash the screen properly.
Jack
09-01-05, 05:32 PM
Hmm... mine wash fine... better in fact as you get two jets per washer rather than one. If in doubt, get some that have adjustable jets so you can use a pin to position the water jet.
Custom_Calibra_Nova
09-01-05, 05:48 PM
mine spray a mist of water, not just jets, so they wouldnt work in the o/e position. they look better in the bonnet anyways.