no temp reading

[Gunzi]

I have had no temperature reading for a while now I replaced the temp gauge that screws into the block under the inlet manifold and this made no difference, still no reading!

Could the problem be the thermostat?

[Will F]

It will either be the thermostat or you dont have any water in it!! :D

[James B]

check how clean the metal is on the contacts aswel for the temp sender

[Gunzi]

The contacts are fine on the sender unit, so I'll check the thermostat? any ideas what to look for or would it just be fuct
gunzi

[Chris]

Disconnect the blue wire that goes to the temperature sender, turn the ignition to II then uses a multimeter to measure the voltage on the blue wire. This should be +12v. If it is then hold this wire to earth and the temp guage should go into the red, this means your temp sender is dodgy (or you have no water in). If the +12v is not present then you either have a fault with your clocks or wiring between your clocks.

Good luck

Chris

[Gunzi]

quality, Cheers Chris16v
will give it ago @ the weekend

P.S I have water in my system!