View Full Version : brake conversion
J122LVR
11-12-04, 11:40 PM
does any1 know anything about putting calibra 16v front brakes on a 1.2 nova my car is a 1.2 flair with 1.4 engine in it. do i need to change anything along the lines of my servo pumping my brake fluid as there is no presure after bleeding them. thanx craig
should just be a straight swap, should need to change the servo,
im sure a few people om here run a standard servo with 16v brakes
You don't have to change the servo, i wouldn't bother.
You need at least 14" wheels to fit 16v calipers under though.
J122LVR
12-12-04, 12:04 AM
i have astra 15's on
J122LVR
12-12-04, 12:09 AM
problem is theres just nothing no pressure wot so ever i dont understand it i have even bled the rears
Sounds like theres a leak in a pipe and letting the pressure out, or the seals have gone at the master cylinder end.
J122LVR
12-12-04, 12:15 AM
if there is a leak then what would u recomend doing i.e. new pipes or just go to the scrappers
Well pipes from a scrap car will probably be rusted, and maybe leaking themselves. Just get some a new pipe fitted where the leak is.
Have you noticed an patches of fluid on your drive floor or anything.
J122LVR
12-12-04, 01:01 AM
not noticed but my brakes were working today untill we changed them over then we couldnt get no joy then when putting back on the normail 1's they don't work either now :(
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.