Oil pressure sender unit wire

[Snowface]

i'm swapping from a standard unit.

do i just run a wire from the 2nd connector to the spare spade on the back of the clocks?

There are 2 spades (connectors) on the back of clocks. One of them is in use for the rev counter. Is the other spade for oil pressure or do i need to wire it some other way?

cheers.

[johnnynova]

did it on mine took 10min, ezy

1 connector free on sender, take a cable to this, run it behind the dash, take the dash out, look where the oil pressure gauge is, roughly behind it is a terminal to connect a witre to, bodge it or solderit to that and hey presto! shoots up wen u rev/1 starts high unitl oil is warm, mine goes below half wen idleingn after being on for 30min

hope this helps

[Snowface]

cheers.

[LiD0N]

the wire should already be there u just need to connect it up.. if it isnt run a new wire..