View Full Version : Flat Boot Pan
I want a flat boot pan welded in and my spare wheel well removed...
Its for show purposes, obviously it will need strengtheniong, any idea on how much roughly this well be?
Could I have a fibreglass one to reduce weight?
Thanks
Paul
i cut mine out 4 my zorst ,
i just cut the well out and welded in a new plate
novaexplod
26-08-04, 04:47 PM
i wudnt use fibreglass as it would be highly prone to cracking
i cut mine out 4 my zorst ,
i just cut the well out and welded in a new plate
Did you not put some sort of bracing in between the chassis rails? When I do it I always put 2 pieces of box sections in between the chassis rails.
Chris
Al Wilson
28-08-04, 09:11 PM
It isn't structural though is it? Mine has been done using the existing edge of the boot and two pieces welding over it. Rear strut helps rigity as well.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.