View Full Version : 2.0seh 8v engine conversion NEEDS/MUSTS?????????????????
work_in_progress
16-08-04, 02:09 PM
just wondering wot r musts or deff needs 4 when i convert my engine from a 1.0 2 a 2.0 8v i know i need 2 up grade breaks/suspension but wot else is there if owt cheers
its all the same as a XE convertion mate
work_in_progress
16-08-04, 02:50 PM
well i dont know about them either lol first conversion 4me
just look at the guides on valvers.com etc for the xe, i will say that you dont have to do the clutch cable mod tho or the heater matrix one as they come no where near the 8v. :D
work_in_progress
16-08-04, 05:17 PM
help much apreshiated thx
?65 from cossvaux in sheffield.
It IS possible to use the 1.2 box and shafts cos I did this with my 1.8 8v but it'll probably rip them to bits!
I'll explain if needed cos it's quite long winded.
Drivers mount just needs lowering about 2 inch, chassis leg need a beating and the exhaust needs bodging but apart from that its easy.
Oh and wiring but that is a piece of cake, std alternator and starter and guage senders to be used from nova, dizzy and ign loom may well be needed from donor car.
work_in_progress
18-08-04, 08:51 PM
wot about fitting a 2.0i turbo nissan silvia engine?
silvia engines were 1800's bitch! the driveshafts u need are nova GTE with cavvy MK2 inners from the 1600 big blovk... fits easy! 28 for the inners new!!
the rest piss of piece:P...just with the 1.0.. need to change the ignition wire, red i think to a bigger wire as the 1.0 runs on 9v not 12-14v as the 1200 onwards runs!!!!!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.