Couple of questions (help :)

[Jonlem]

Hi there,

Rather than write up a few threads I thought I may as well put them all together and hopefully I'll get a few answers :)

1- Why doesn;t the search engine work on NL ? lol just curious

2- I'm using Compomotive MO's ET 46, under hard cornering I'm sure the back wheel is catching on something either the inside or outside of the arch, they have been rolled which makes me think it is on the inside. Can I run spacers to bring the wheels to a true ET49 or should I not expect any problems from this offset?

3- Do TD novas run a rear anti roll bar and if not should I run one?

4- Got a rear beam of a Astra Gsi, does anyone have any drawings of how to convert the bits onto the nova beam, I'm using AP 4 pots up front so will i need the bias valve too? the car is stripped completely

5- I've seen some seperated wastegate downpipes for sale on Mig, I'm still waiting to hear if they will fit on a nova, has anyone had any experience with one of these and also what diamater exhaust pipework did you use?

Sorry for all the questions but the search engine isn't working so Its made finding things out a little awkward.

One last thing, I'm using Rally Design red bushes and it seems like the car has gone real sloppy since I''ve done a few 1000 miles. Everything seems to move and creak now and things won't go much tighter, does anyone have any good suggestions on a LET nova handling setup?
I may put up another post about this as it would help if the car would actually go round a corner!!

Thanks again

[-Bruce-]

1. dont know why it does not work!!

2. i would have thought that you would not have anything scrubing on the wheels with the offest you said. maybe there is somthing protruding from the inner wheel arch??

3. yeh TD novas have a rear ARB.

4. if you were to fit the disks on the back, i would say a bias valve is a must!! dont have any drawings of the set up sorry.

5. not sure mate

and as for the suspention setup for a LET have a look through the feature section on the site, see what everyone else is useing and speak to them and see what there set up is like pros and conns etc.

bruce

[nam]

sorry but i only know 2 questions............

1.it has never work and probly never will lol

2. you should be ok with that offset as bruce said, if the wheel was catching then would there not be signs on the arch and wheel???

nam