Tacho connections

[jock76]

Help, does anyone know where the connections go into for an after market 12v negative tachometer. The coil connections are a bitch to suss out! :evil:

[dan-hipgrave]

The bottom right connector in the ignition coil is the tacho signal. Take live and earth from other wires behind the dash. That should be all it needs to work.

[jock76]

Is that the same for an electronic ignition system? Cheers :?

[mark_GSi]

should be m8

[jock76]

Nice one, i'll give it a go! I take it, its bottom right looking at it ( Wires going to the Distributer ). Hope so.....

[jock76]

Im still getting no love! The coil has 3 wires, red n black at the top going to the dist. and a single black at bottom going somewhere. Help!! Any clues would be cool :roll:

[jock76]

Help

[dan-hipgrave]

ok, if yours is the same as mine you will have.....

A red wire in the top left connection, and a black wire below that..

Then, on the top right you should have a brown wire, and the connection below that should be empty... that is where you plug in your tacho signal wire.

If there is a wire already in its place and it is green then you already have a tacho signal and you just have to look in the loom behind your dash and you will probably find it taped up and not being used....

[jock76]

cool, sorted it, nice one man!!