david dixon
09-07-04, 01:07 PM
Its from SBD, A complete 3D system to run with carbs on a 2.0 16v (xe)
AT the moment its not mapped for a standsrd engine with carbs but sbd will remap it for ?80
Here is the spec its mapped at:
Weber 48's,
flowed inlet manifold,
ashley race exhaust manifold,
head matched to both manifolds and flowed from inside to out,
piper 285 profile cams (road/rally),
vernier pulleys,
double valve springs,
2080cc
and rev limit set to 8000rpm.
But remember all this could be changed to match your engine!
Make me a serious offer, it cost me nearly ?650
AT the moment its not mapped for a standsrd engine with carbs but sbd will remap it for ?80
Here is the spec its mapped at:
Weber 48's,
flowed inlet manifold,
ashley race exhaust manifold,
head matched to both manifolds and flowed from inside to out,
piper 285 profile cams (road/rally),
vernier pulleys,
double valve springs,
2080cc
and rev limit set to 8000rpm.
But remember all this could be changed to match your engine!
Make me a serious offer, it cost me nearly ?650