indicator wiring

[gary_1.2Merit]

im tryin to wire the indicator falsher of me alarm to de indicator switch but i have a problem. the max power haynes says sloder them to a green/black and a green/black/wight wires. ive done this and only de right indicator flashes. both de alarm outputs are getting +12v. de nova haynes wire diragram says dat the left hand wire is wight/black, but i aint got a wight/black wire dere.

i tried it to a wight wire n dat flashed the headlamps.
de wires ive got at the switch are
grn/black
grn/black/wight
whght

red
black
yellow
wht/yello


any help with which wires to join my alarm 1s to?

[david dixon]

have you tried putting them to one side of your indicator wires or use a electrical tester to find out which wire is live on your hazard switch when its switched on.

[gary_1.2Merit]

i had them to the 2 wires at the hazard switch which go +12 wen the hazards r on, but de indicators did not flash

[robb]

There are two wires on the indicator stalk, try wiring into these, check the manual wiring diagrams to see which wires are which.

You have to do this when wiring in a digidash to get the dash indicator working. check out a digi dash guide to see. one on nova land.