digi dash

[Mike.]

I'm after a digi dash and i,m wondering how u would fit one to a mk2 1.2

[dan-hipgrave]

It would fit pretty easily into a mk2 dash.

Get hold of the digi dash, both plugs and about 2-2.5 inches on the loom connected to the plugs as well as the transducer that goes with the dash, then basically wire the plugs up colour for colour to your existing nova loom, if you dont have a wire for the rev counter then run one from the coil (bottom right connector), to get the oil pressure gauge working correctly you need to change your oil sender for a two wire one from a GTE/GSI i think, otherwise it will constantly read maximum but this is no problem i have left mine like this. Unscrew your speedo cable from the gearbox, screw in your transducer and run the wire to the back of the digi dash.

Then all thats left to do is modify your dash surround to fit the digi dash in, just bend back the lugs that you screw into, put the dash in, and then put the lugs back into place.

There is a more comprehensive guide on www.nova-land.com

[Mike.]

cheers for that m8