View Full Version : Vernier Pully
krobinson
31-05-04, 12:36 AM
I'm looking into buying a Vernier pully. I'll be running a piper 285 cam, so would i be best with a piper pully? I dont want to be spending a fortune, so does anyone know where's cheap to get them?
There was a 1.6 pully on Ebay, but its square tooth and i need round (1.3) :(
Keith
rallyxnova
31-05-04, 02:55 PM
HI Keith,
I see your from Northern Ireland too..
You dont neccessarily need a Piper one, a kent one is the same..
Give Steven GAult a call, hes in Northern Ireland, (he built my engine,)
He can make you a vernier pulley , he made the ones that are on my engine, but they take a lot of setting up, as they are done on a solid follower.
Mark
Guess who is buidling Keiths engine :roll: :lol:
krobinson
31-05-04, 07:02 PM
Stevens currently building my engine mate! He was asking last night if i was gonna get a pully or have him make one! He suggested buying one as he could have a perspex cover made to show it off!
Keith
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.