Boot fitting and indicators

[hasek-na]

Hey everyone just got a flushed boot and am wondering how to fit it lol. Is it take bolts out switch boot over and bolt in or is there somthing more forceful needed (e.g hammer) Its a mk1 by the way.

Also whats the procedure for removing Mk1 side indicators to put clear ones in.

Thanks

[isrs]

have you fitted your indicators yet, just baught some for mine, so wouldnt mind a few tips, if any.
havent looked at how to fit them yet so, is it hard? mk1

[mowgli]

undo the hinge pins whilst a mate hangs on to it.

the indicators are easy. just remove the headlight assy. the rears need unscrewing

[hasek-na]

No havnt done them yet but seems simple enough I'm sure I'll get what you mean once i have a proper look. Cheers

Do you think this was a good deal it is a flushed boot (fully) slightly bad boyed across the lights - ?50

[mikeyredtop]

i balanced the tailgate on my head, while i tapped the 2 pinns in, managed to scarch a bit of paint so dont do it this way...

[nova_rally]

If you mean side repeaters then it's very easy: remove orange plastic cover, then use a srewdriver to lever the clips in and pull on it - out pops bulb holder... You may need to change this, you ay not. If not then just pull the orange thing off and on goes the new one...

Alan (Just been messing about with side repeaters for the new Wing)