View Full Version : immobliser switch
gary_1.2Merit
23-04-04, 11:11 AM
which wire would i need to break into to put a switch in so the engine wont start wen its not on? i know its sumthing to do wit the coil or dizzy cap, but its not a HT lead coz that wud be stupid!!!
the black one from the coil i think.
you could cut feed to the fuel pump relay, may be easier as i think you can just go in theback of the fuse box.
te17@novasgonemad
24-04-04, 12:42 PM
NAH U WONNA CUT THE SMALL BLACK RED FROM THE BARREL ONLY THE SMALL ONE THO AS THAT IS THE SIGNAL CABLE IF U CUT THE LARGER ONE THEN THE SWITCH HAS TO REALLY COPE WITH SOME SERIOUS AMPS:)
Aragorn
24-04-04, 07:11 PM
small black/red does the starter
cut that and u can still bump start it
u wanna cut the fuel pump relay or the black to the coil
or both ;) on seperate switches hidden in different places ;)
~~joycey~~
24-04-04, 08:04 PM
just use the black coil wire and hide the switch up under ur dash so only YOU know where it is :roll:
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.