arches rolling or not?

[johnnynova]

ive got 195/50/15s and an lower my mk2 nova -60mm all round

im angle grinding back the rear arch lip (slightly) as it scraps every now and then (with 2+ poepl in the back)

will i need to get them rolled tho???

[cooper_nova]

do either one or the other

[Jack]

rolling them would be better than griding them

[Aamir]

Arch rolling is roughly about ?25-?30 per arch
With the right offset, you can have upto 17's with rolled arches (think future plans?)

But don't flare them.

[cooper_nova]

[quote="Aamir"]Arch rolling is roughly about ?25-?30 per arch
With the right offset, you can have upto 17's with rolled arches (think future plans?)

is it really that much????? :o

[Aamir]

When done properly, yes. There's no paint damage or panel distortion.

I've seen cowboys (yeehaa) roll arches with a panel beaters hammer & flare the arches with a jack :o , but then there is the cost to re-skim the quarters.

Get it rolled, I have & it's very neat.

Grinding the lip is ok, but make sure not to go to the spot welds as the panel will split.

[cooper_nova]

my rear arches were grinded by the previous owner and he's done a top job