View Full Version : preditor
badnova
24-03-04, 12:20 AM
got a preditor spoiler from supernovas and want to know the easiest way to mark where to drill the holes
any help plz becouse i aint got a clue
Put a piece of masking tape roughly where you want to drill. Use a felt tip pen to mark exactly where on the masking tape and then simply drill there through the tape. The masking tape will also stop you from ruining the pain around the hole
Mine came with some stick on padded washer type things. One side was sticker than the other so i put them on the spoiler, lining up with the holes on the spoiler, then put it in place on the car. Took spoiler off, and the sticky pads stayed on the car, showing the right place to drill the holes.
blingmachine
24-03-04, 04:10 PM
i just tigersealed mine on 8)
but only coz i drilled it wrong :oops:
but only coz i drilled it wrong :oops:
if the holes don't fit, jus' drill 'em bigger til they do :lol:
~~joycey~~
24-03-04, 04:50 PM
:lol: :lol: :lol: :lol: :lol: :lol: :lol:
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.