View Full Version : RamAir & K&N airfilter part Numbers please?
Snowface
13-03-04, 01:17 PM
I would like to know the above for the Weber 32/34 DMTL.
I think ade knows the RamAir.
Also is RamAir much better? Can't water get in through the top of the filter (K&N have metal on top).
Cheers.
mikeoxford
13-03-04, 03:04 PM
ramair is much better for performance.
think about the k&n - u have to have the short one for the 32 34 because otherwise the bolt heads will end up dinting the bonnet.
so thatll leave possibly a 1 and half inch strip where air can get in?
ram air being completely foam (or a pipercross one for that matter)
sucks from all angles. MUCH better.
as for ramair gettin water in your loosing the point a bit.
if water (u think) will get in the top - itll get sucked in the sides too! so its not even worth thinking about as theres no argument for it.
BUT.
water wont get in anyway.
where can it?
unless u have a scoop or something directly above.
dan has a scoop directly above his t40s, and when hes been out in rain the socks are a little damp - at least he knows the scoop works!!!1
mikeoxford
13-03-04, 03:05 PM
PS:
i can dig out a part number later if ade hasnt come up with the goods :twisted: :lol:
Snowface
13-03-04, 04:50 PM
cheers mike, i was thinking going RamAir but wasn't sure.
They about the same price as K&N's? (?50)
mikeoxford
13-03-04, 04:54 PM
sure am.
ill find pt number for you l8a
Snowface
13-03-04, 05:00 PM
aha
i just found a PM ade sent me ages ago with the number in.
rs2/239 with 40mm (medium) foam top
Does that look right mike?
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.