View Full Version : sri manifold / lambda
I got a sportex manifold for my sri, went to get it fitted and the guy at powerflow says its the wrong 1 coz the hole for the lambda sensor is to far down. is he right or can i get a longer wire for the lambda?
you can simply extend the wire for the lambda sensor
Ste_Nova
23-02-04, 11:53 AM
you went to powerflow to have a ready made zorst fitted?
ya they made my system and when they fitted it my down pipe bracket snapped :o so they had to weld a pipe between the system and the down pipe so i need a bracket putting on my system to fit the manifold...
Ste_Nova
23-02-04, 11:57 AM
powerflow monkeys :lol:
think i will just go to my loca garage and see what they can do
fuckin waisted my saturday going to leeds for them to make me wait 2 hours, then tell me its the wrong part whenit wasnt!!!1
fucking shit bastards!!!!!
:evil:
:evil:
:evil:
:evil:
pardon my french!!!!
im just not impressed by theses amatures!!!
Snowface
23-02-04, 06:20 PM
I think powerflow is a franchise, so don't judge them by the qork of 1 garage. my Powerflow garage did a good job on my car and i'm very happy with them.
Aragorn
23-02-04, 10:34 PM
what u will find is if its too far away from the original position (ie in the 4-1 collector) u will need a heated probe cos the probe wont get hot enough down there and wont work right
mikeoxford
23-02-04, 10:54 PM
not that im an expert - i aint got a clue about this subject
but there was talk that velos can buy in el cheapo rover lamda sensors (heated) and these are the best money can buy.
Aragorn
23-02-04, 11:06 PM
u can buy heated zirconia lambdas online for ?30 ish which is what the rover uses
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.