View Full Version : how do you get the oil pressure dial working?
johnnynova
19-02-04, 09:53 PM
just fitted gsi dials to me 1.2 carb, got the rev counter working! revs till 7000rpm easyily!
but am wanting the oil pressure to be working to.
advice, thanks
john
mmollart
19-02-04, 11:02 PM
you need to change the oil level sensor for the gte/gsi sensor, not sure but i think you need a two wire sender or three wire, one more than you already got neways, the extra wire goes to the oil pressure gauge, dont hold me to it tho, im sure someone else will correct me
anyone?
"revs to 7K easily" dont expect that for too long lol
Nova_Tek
20-02-04, 06:25 PM
Yep thats rite,
You will need a 2 wire sensor to replace the 1 wire sensor you alredy have. (located rear of the engine drivers side. remove the front wheel to get a clear view of it.)
One wire will plug in normally but the second will need to be wired to the back of the oil pressure gauge on your clocks.
I just did the same on mine. Takes 15 mins to do and thats it.
hope this helps
what car does he 2 wire sensor have to come off?
i mean can i go down scrappy n get 1 of a cav or something?
mmollart
22-02-04, 09:02 PM
nova gte/gsi not sure bout the sri, think the sr's have em too
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.