View Full Version : dASH fitting help, quick im doing it now!
johnnynova
17-02-04, 04:16 PM
just fitted gsi dials to my 1.2 carb, i know i have to run a wire form the coil to the back of the dials, problem is i cant see now green wire near the coil!
or coming off it?
where is it!
and will the oil pressure meter work??
cheers
john
geordie_racer
17-02-04, 04:20 PM
the wire needs to go to the negative side of the coil if you look closely you'll see the + and - signs.
as for oil if you have a 2 wire sender and plug the blue/yellow onto the clocks then yes it should
chris
novashed
17-02-04, 04:33 PM
yeah you need a two wire pressure sensor, 1.2 probably has a single wire one
johnnynova
17-02-04, 04:38 PM
just looked at the coil, cant see a -ve or +ve sign!
there are 3 wires going into it, one nearest the bumper (black) then furthest from the bumper, is another black (i think) then a grey one under it. which one is the negative !!!
cheers
john
geordie_racer
18-02-04, 08:53 AM
take the connector off the coil that those wires are attached to and ull see the signs on it then
chris
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.