amp question

[1.2 NOVA]

i am goin g to b getting a JBL 4 channel amp soon and i was wondering if i cud wire it up and only use 2 channels 2 run my 6x9's till i get a sub. wat wud happen if i did this?

[srs1]

a usaul 4 way amp is around a 600 watt area so a 2 channel bridged will be around 2x 300 watt. so the bottom line is really. i hope you have a decent set of 6x9's to take the power. otherwise exspect alot of distortion and finally they will pop!

[epo]

a usaul 4 way amp is around a 600 watt area so a 2 channel bridged will be around 2x 300 watt. so the bottom line is really. i hope you have a decent set of 6x9's to take the power. otherwise exspect alot of distortion and finally they will pop!

they wont be as bad if the gain is turned right down

[badnova]

simpleist thing is to just wait and ont fu*k your speakers up

but its your choice

[trickynova]

most 4 channel amps av a switch on them to only run 2 channels out of da 4, even if u cant do that just use the 2 channel with a (FULL PASS) setting. it wont do any damage not 2 use the otha 2 channels anyway

[Adam]

Am i right in thinking that you could just use a four channel amp to power 2 6x9's, and the other two channels to bridge a sub.

[trickynova]

u can do that as long as 1 of da channels has got a (LOW PASS) setting, u also need to have a hu wid at least 2 preout other wise u wont b able 2 use da fader on da hu