View Full Version : FAO any mk1 - mk2 dash conversion owners
What method did you use to join the new plugs to the old loom?
I was gonna use solder but have heard that it gets brittle with age and that causes dry joints :?
Thanks in advance :wink:
dan-hipgrave
14-02-04, 03:49 PM
i used crimp connectors if that is of any help mate
I had mk2 dash in my re-shell but my loom was GTE...
Solder the wires and use heat shrink afterwards. The only way it will become brittle etc is if the wiring is bent and twisted around, because solder is not flexible. Every panel/board inside your PC will have at least one soldered joint (usually wave soldered which ISN't as good as hand-soldered) and it's quite rare if it's done pro[erly.
Heat shrink keeps the wiring tight together minimising the chances of a dry joint disrupting connection
Oh and I am BEng in Electronics and Electrical engineering so my advice is sound
Rick
also when soldering dont blow the solder to make it dry quicker as that causes moister in ur breath to get in the solder
mine was soldered but properly its like weilding if you do it right it will last forever then use heat shrink wrap :lol:
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.