sri clocks

[paul123]

hi i have a mrk2 nova i just got sri clocks i have 14pins on my plug and the sri clocks have 14 pins too i have pluged them in and the rev counter do not work how do i make it work where do i run the wire from on the sri clocks and where to on the coil. there are two wires on the coil which one

thanks

[Cheese]

The terminal for the rev counter should be directly behind the dial, it will be a single spade terminal sticking out.
You need to wire this to the negative terminal on the coil. You should already have the wire taped up in the loom at both ends, its a light green colour.. Just connect it, and everything should be fine :)

[paul123]

i have check my loom the green wire is not in my loom but it is a light green wire going in the coil is this it

thanks

[Cheese]

If its connected to the negative terminal on the coil, then yes, thats it.. The other end should be taped up will the cables/multiplug that connects to the back of the clocks :)

Hope that helps

[paul123]

which wire do i put the rev counter to the green or the black

thanks