Exhaust options for valver, whats best?

[Zak16v]

Hey so i now have my valver engine and im prepping the shell first with a good clean up plus all the necessary strengthening and a paint job. Im wanting to consider my options for fitting an exhaust to the engine.

I have a 4 branch manifold to go onto the engine from an xe block, i was considering getting my local custom exhaust place to make me a full straight through stainy going from the manifold to the back box which will be a 4 inch straight through jab style can.

Would this be a bad move and far to loud?

Im not too sure what to do here guys so any help would be greatly appreciated.

Look out for the project appering in the 2.016 valve section soon tho!

Cheers!

[Beano]

I dont know a lot about the engine, but I would think a straight through would kill the power from the engine, and attract far to much attention from rozzers. Get your exhaust custom made by a specialised exhaust place, it might cost a bit more, but they're gonna know what they're doing and you'll get the best exhaust you can.

Unless someone makes a nice s/s system :?: Like Magnex, or Scorpion maybe?

Im sure that didn't help...but I tried! :lol: