Twin exit powerflow

[doberman8386]

Hello I just wanted to know whether any on ehad had a powerflow twin exit done and how much it cost, I just want one that has a boxster end on it.

Thanks

[epo]

do u mean like thishttp://img9.photobucket.com/albums/v24/epo_sri/Picture_016.jpg

or the same side?

[Dpnova]

How much did you pay for that epo :?:

[epo]

i paid ?50 that was for the stainles pipe and the tail pipe
powerflow wanted ?100 to fit it but i still had 2 move all my fuel pump and stuff so would have been expensive so i did a deal with a mate i wire his garage he fits that + some other bits i also helped fit it for a bit of knowledge

[Dpnova]

There nice mate

[epo]

thx

[a2lt16v]

THAT IS WELL CHEAP. I WAS ABOUT TO PAY 500 FOR STAINLESS SYSTEM WITH TITAINIUM TAIL PIPES ONE EACH SIDE. WHERE IS POWERFLOW

[Dpnova]

There all over the place, What advantage do you get from titanium tailpipes :?:

[a2lt16v]

you get a much deeper softer sound without the rasp. also they constantly change color as the heat changes but they are hard to clean

[Dpnova]

Got ya, sounds good, are the expensive then

[a2lt16v]

my mate got a 5 " slash cut on his cav for 450 from downpipe back. onlyth erear box is titainium

[Dpnova]

that aint to bad then, where do you get them from

[a2lt16v]

that is bad as mate up the tops was 50 pound. they are from a place in southampton STEALTH SYSTEMS

[Ben3042]

Rage make a few titainium rear boxes i think