Chris S
05-01-04, 01:06 PM
the header tank on the calibra was on the drivers side bulk head.
on the inlet manifold there's a rubber block with 2 pipes running threw it.
do i cut a line down the middle of the block and pull it apart? or is there another way?
and is this the pipe that t-piece's into one of the water pipes if so which 1??
Cheers Chris S
on the inlet manifold there's a rubber block with 2 pipes running threw it.
do i cut a line down the middle of the block and pull it apart? or is there another way?
and is this the pipe that t-piece's into one of the water pipes if so which 1??
Cheers Chris S