View Full Version : Magnex Exhaust
Dan_Dan_The_Nova_Man
04-12-03, 11:16 AM
I am currently running a Magnex exhaust on my early Nova GSi and would like to remove all silencers, however Magnex do not offer the parts required to do this. I would be grateful if any one new of a comapny that may be able to help me or would it be cheaper to just buy a straight through. Thanx
Ste_Nova
04-12-03, 11:38 AM
just get some straight stainless pipe from ces or other zorst place
get a local garage to weld it in
dangermousegsi
04-12-03, 02:57 PM
mr exhust/kwik fit will supply an fit u a straight through centre section (my local kwik fit did) be warned u will wake the dead :!:
As well as waking the dead, you'll pi$$ your neighbourhood off and attract a lot of attention from the police and it'll probably fail the MoT on the noise level.
:wink: But apart from that, go for it...LOL
doberman8386
05-12-03, 10:19 AM
If you do that will it make your car go slower or will you not notice any difference
dangermousegsi
05-12-03, 01:42 PM
i did it an it didnt seem to make a differance, with that exhuast set up an a k&n 57i it made 119.7bhp on the rollers.
From what engine? Cos if it's a GTE / GSi then that's almost 20BHP from a 57i and a Magnex exhaust!! I'd go to a more accurate rolling road in future!!
:o
dangermousegsi
05-12-03, 04:05 PM
it was a gsi engine
i had it rollin road tuned at a place called motorvation in dorking(surrey) i dunno how acurate their rollin road is but they seemed to have a pretty good word of mouth reputation.
it was a hell of a lot better afterwards though
anyone of a good rollin road in the southeast i could use in future?
Ste_Nova
05-12-03, 04:08 PM
but they seemed to have a pretty good word of mouth reputation.
?
if you got 95bhp would you recomend them?
dangermousegsi
05-12-03, 06:05 PM
what i ment was i spoke to ppl who used them for mods an servicing an they were all pleased with the service so thats why i went there.
Ste_Nova
05-12-03, 06:30 PM
pleased with the service = high power figures
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.