View Full Version : camber mod
i read the guide on it and it says drill the holes 7mm towards the wing, does that mean the edge of the new hole needs to be 7mm from the old or do u put the centre of the drill on the 7mm mark. Any help appreciated..
dave.gsi
16-11-03, 08:39 PM
i dont think it really matters that much as long as you do both sides the same.
dikharvey
17-11-03, 01:02 PM
i was goign to do this but couldn't work out how to make the large hole i the cneter move 7mm sideways.
Also worried about it failing it's MOT.
Ste_Nova
17-11-03, 01:43 PM
http://mig2.lathwood.co.uk/r.php?d=c&f=camberz.jpg
did mine had no probs with MOT
you dont needto move the centre hole!!!!! only the two small holes!
this is what id recomend..
suspension drop / camber ajustment
0mm / 0mm
30mm / 4mm
45mm / 5mm
60mm / 7mm
this is only what i recomend not saying these will be perfect for all cars!
Ste_Nova
17-11-03, 02:04 PM
those setting are all 'lower than sri/gsi'
Ste_Nova
17-11-03, 04:09 PM
60mm lower than gsi
novaexplod
17-11-03, 04:59 PM
can u just file the hole 7mm across then? n use a bar to move the whole lot across?? :roll:
loosen 2*13mm nuts, jack car up a bit, make a mark where ur gonna file to, file the holes, lower car, pull strut across to outside and hold it there while u tighten the 2 nuts up tight.
then off to get tracking done!
if your happy with the result then might be worth welding 2 metal washers in place but not really needed
geordie_racer
18-11-03, 02:33 AM
sorry been on this board ages and this is the 1st ive seen of a camber mod, what are the benefits of it? i assume its just a case of shifting it by the set distance against the lowered amount? also if its against a gsi what would be the adjustment for a 1.2 nova lowered 60mm?
cheers
chris
Stanton
18-11-03, 07:52 AM
0mm / 0mm
30mm / 4mm
45mm / 5mm
60mm / 7mm
how much u rekon 4 a 100mm drop on coilovers?
does this just stop tire wear or does it make the car handle better :|
dave.gsi
18-11-03, 12:32 PM
apparently both
stops tyre wear really. but makes the car feel better i thought aswell
so the point of the drill does go 7mm from the edge of the old hole??
Ste_Nova
19-11-03, 02:02 PM
no... 7mm center to center
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.