View Full Version : Fitting Carbs to a GTE
Right for the time being i am going to fit some twin 40 webbers to my GTE.
I know that i need the choke size to be 32mm and i also know about all the linkage and altenator bracket.
What i need to know is hw to go about setting up the ignition side of things as obviously the standard ECU etc will be scrapped.
What Coil and distributor is the best choice and will any others do?
Aragorn
13-11-03, 02:58 PM
1.4sr coil and dizzy is prolly about the best to use
or just any 1.4 not mpi/spi
i removed one from a 1.4 L, as its the same engine as the sr lol
yup 1.4sr is the best way as this is the same setup as i am running
ahh well thats not good enough as my engine will leave yours standing when its done :!:
ha ha ha ha
I love fighting talk :lol:
Jim
1.4sr coil and dizzy is prolly about the best to use
Same as what I used.
i have an inlet manifold if u need one. 50 quid
used it on my gte and it went well. i used the 1.4 sr dizzy too
Adam Moran
14-11-03, 10:58 PM
Whilst were on about dizzys, im going to be using the dizzy from a 1.3sr. I'm gussing it will do the same job as the 1.4 one?
I mean it just hast to be adjustable right?
Ad
Oh itsa 1.6 8v T40
Aragorn
14-11-03, 11:08 PM
1.4sr dizzy and coil setup is more powerful than the older 1.2/1.3 setup
Oh I meant to post this in my first post, it's a simple drawing I knocked up to show my mate how I'd wired my 1.4 dizzy & coil.
http://homepage.ntlworld.com/julian.sumner/1400%20Wiring%20loom.jpg
im even more confused now jules :!:
Aragorn
15-11-03, 07:50 PM
lol if u take the loom off the 1.4 sr you'll see its all self contained bar one plug that goes to the car loom
this plug has switched 12v, ground and tacho feed on it
1400 Carb'd astra coil dizzy anygood?
Aragorn
15-11-03, 09:18 PM
yup same engine
coil should be round with a 6 pin module underneath
2 pins on dizzy and 2 pins on coil itself iirc
im even more confused now jules :!:
Jeeezzzz Ben the pic isn't exactly brimming in detail and hard to understand!!
Once you've got the car in bits and the wires infront of you it'll all make sense (At least I bloody hope so cos everyone else that's used it has worked it out alright so far!!!!!!!!!!)
:o
does the dizzy from the 1.4 fit the 2.0 8v as im putting 45s on my nova and they dont do a carbed 2.0
I wonder where you will get the 1.4 coil from Ben?!
My old man was wondering why the Astra wouldnt start in the garage :roll:
Austin_Nova16
18-11-03, 05:28 PM
m.d. - use a 1carbed 1.6 mk2 cav dizzy and ign module. Should fit fine.
My old man was wondering why the Astra wouldnt start in the garage :roll:
I think the coil missing of that astra is the least of the problems!
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.