Getting a rev counter to work in a 1.2

[moffat sri]

I'm puttin some SR clocks into someones 1.2 tomorrow. Will the rev counter work straight off or will i have to bring the wire from the coil as described in the Nova modifying manual?
If i have to bring a wire, where does it go to on the SR clocks?

It's a H-reg 1.2 carb, and i'm putting some Sr clocks out of a J-reg into it. Will everything else work straight away?

Cheers.

[Aragorn]

as long as its mk2 everything should work streight off

if its a mk1 your gonna have fun even fitting the mk2 clocks never mind making it work :p

as for the wire it goes to the green wire on teh clocks - im sure its a spade connector or summat for it

[geordie_racer]

if its going into a mk2 then as aragorn said it should be all ready wired up if not it's a simple job to run the wire from the coil just tape it to the current loom

chris

[Austin_Nova16]

it will be a green wire on the clock wiring harness. Run this to -ve on the coil.