mikeyredtop
31-10-03, 01:59 PM
ive relocated my lamda sensor to the mid section just after the flange, because my 4branch was off a 1.4sr not sri, so it didnt have screw thread for it... i used a nut for the mid section which was the wrong size but it worked, just, with paste to prevent blowing. i wanna put it on the 4branch now cause the ecu light comes on sometimes with the fault code for the lamda sensor. but i wanna use the correct size thread, done properly. does any know what size nut to use? :help:
i wanna do this before i put the c16se engine in as i want it to run right..
i wanna do this before i put the c16se engine in as i want it to run right..