Single Wiper

[Anonymous]

Does any 1 know where I can see a guide for a single wiper conversion kit without using a ready made kit??
Also have u used it and doesit work well??
Fraz
:D

[Anonymous]

i have made one its works fine apart from knockin on the scuttle panel on the inside!!

1. Remove passanger wiper

2. Open bonnet and remove the linkage.

3. Cut off the half that is not needed

4. there should be a "T" shaped piece. remove about 10mm from the vertical section of this (will need to be weled back 2gether)

5. Put linkage back in

6. find a straight wiper arm for it!!

7. if u get his far e-mail me and i'll exlain how 2 set it up!!

RobDmr@aol.com Xr2????? I'd rather walk!!!!

[Anonymous]

and next time on technical forum please!

*************************
X-( I'm mean and i don't care :D
[burn_ford] <-- best thing for them!

Ian@novaload.net
*************************

[Anonymous]

that should read drivers wiper not passengers!! does it really matter Ian!! :p

RobDmr@aol.com Xr2????? I'd rather walk!!!!

[Anonymous]

DONT TAKE 10MM OUT !!!! JUST TAKE ABOUT 7MM OUT. CHECK THE TECHNICAL FORUM FOR QUESTIONS CALLED SINGLE WIPER AND READ THEM BEFORE YOU START !

I H8 fat wankers in Lorries !!!!!
:O:O:O

[Anonymous]

Rob - yes it does matter, what's the point in Kev using his free time to make the forum better by adding categories and then you lot not helping by posting in the wrong one's ??

GSi For sale :)
lee@novaload.net
j903gft@yahoo.co.uk