[b]nova anti roll bar for 2.0l 16v[/b]

[big al 2.0l nova]

have just got a nova 1.2 with a 2.0l 16v under the bonnet. the car has only just had the converson done. i believe that the 1.2 did not have an anti roll bar fitted to it but sr gte did would like to know what i need to do to fit one and how much it cost for the converson kit to lower the anti roll bar and how much an antirollbar is. :D

[mikeoxford]

ive got an antiroll bar kit. ill deliver it to you for ?35. there quite heavy bars of steel etc.

comes with what looks like new bushes.

[big al 2.0l nova]

for a 2.0l 16v

[mikeoxford]

what u have to do is buy conventional equipment and then buy a lowering bracket.

so u need to buy GTE or SR equipment. then use a lower bracket.

[LiD0N]

i think pvd sell the required lowered mounts for ?27 not sure if u can get them cheaper elsewhere..

[steve-o]

when i had mine up on the ramps i found out that rather than fit forementioned kit, they would just take the angleginder to the roll bar!!

[Stuart]

umm theres a contrived debate about with or without an ARB.


i personally prefer to be without mie, i fitted one and the car was a bit skittish (some people like that). so i removed it again lol

[big al 2.0l nova]

is it easy t fit the anti rollbar with the brakets to a car that was origaly a 1.2l

[mikeoxford]

is it easy t fit the anti rollbar with the brakets to a car that was origaly a 1.2l

piece a pie mate

rear ARB is literally 2 bolts.

front is 8

email me at mikeoxford@hotmail.com if your intrested....

theres a fitting guide at nova-land.com > how to guides > mechanical > but the server is down until tomorow.

[Dan]

I also prefer not to run a front antiroll bar, for me it was the best move i have made.

[NovaNeil]

Does anyone find the antiroll bar still catches the manifold after it has already been lowered on a 2.0 16v?

[RJM25R]

The gsi arb at the front still fit's if it's a calibra downpipe, no spacers required.... Do you know what car the valver came out of???????

[Ste_Nova]

i don't run one at the front either... you get no roll with 60mm... with an arb when one wheel is upset the other does too

[mikeoxford]

http://www.novaload.net/forums/article.php?t=63459

[NovaNeil]

Not sure what car the engines from....Is there anyway of telling? The Manifold is a 4 straight into one....if that helps?