PDA

View Full Version : Headlight wiring



marc69
04-08-17, 11:14 AM
Can I take the wiring from my driver side headlight over to the passenger side as a temporary measure with out damaging anything?

Presently my SR is not lighting up the passeneger light, it is not earths, light switch or relay as all have been checked/exchanged. I assume it is either a broken wire or fuse box connection but need to be able to drive as it is my daily.

Jack
09-08-17, 10:00 PM
The better option IMO would be to use the working side as a signal feed on a relay that powers a circuit from the battery for both headlights

meritlover
10-08-17, 04:41 AM
^ agreed

If i remember there is a scotch lock connector tucked under the slam panel which acts as a common between both sides of the loom for the headlights. Have you checked this?

Balley
10-08-17, 02:31 PM
Aren't they fused separately? Have you checked all fuses?

marc69
10-08-17, 04:29 PM
Turns out it was the earth wire after all, re-earthed it and it's fine. I changed each wire one at a time to work out which was at fault, it was the brown one, couldn't figure out the three page wiring in diagram in Haynes so just took a chance that brown was earth. Thanks for the advice and help though!

meritlover
10-08-17, 10:44 PM
Good work