Anyone ever fitted mini wheels??

[Phil_d]

As title, anyone had experience?, can't really find anything that I like without spending a fortune, can buy a set of 5 spoke mini 15" wheels for very little, most of which seem to be 15" X 6.5j and et45 so from what iv read should fit my loon. Haven't found anything about centre bore size yet so just wondered if anyone had experience fitting them ?

[millworm]

Wrong pcd mate

[Phil_d]

All the ones iv looked at are 4x100

[millworm]

New mini is, I assumed you where talking about the old shape

[8valve-craig]

Centre bore is 64mm I think so can spigot ring them down.

I use Mini front brake discs and a stainless ring to centre them.

[Mayoh69]

I've had metro turbo wheels on mine but, holes lined up ok with no cross threading but the centre bore was huge. It came on revolution 4 spokes aswell which I think the mini lads use, look dreadful though.

[slimtater]

See my project thread. The ones I have are 4x100, 5.5x15, ET45 with a 56.1 centre bore. You just need to enlarge to 56.6

[Phil_d]

They're the ones iv been contemplating buying, I think they look really good and that's just the information I needed cheers,

[total_vauxhall]

They are 4x4" pcd pal which is ever so slightly out . however i ran mini wellers 8j on my drag car for 5 years without any problems . never came loose or snapped a stud . worked perfectly fine . just make sure u use spigot rings

Work out to 4 x 101 pcd