jamesbray
02-02-16, 12:20 PM
Hello i have twin 45s with a 2 cable linkage, 2 syntec cables, and a syntec pedal spliter.
there is a hole through the bulkhead were the standerd cable use to go.
what ideas do you have i dont want 2 weld a plate on to cover the hole and driil the new fitting in but would not mind riviting a plate over.
what have you done and what ideas can you give?????
cheers jim:)
there is a hole through the bulkhead were the standerd cable use to go.
what ideas do you have i dont want 2 weld a plate on to cover the hole and driil the new fitting in but would not mind riviting a plate over.
what have you done and what ideas can you give?????
cheers jim:)